MAINTENANCE
All maintenance operations are carried out with the power supply
disconnected. At the end of each work session, or when required,
remove any dust from the body of the tool using a jet of compressed
air, paying particular attention to the motor ventilation slots.
No other maintenance operations must be undertaken by the user.
Maintenance and cleaning of the inner parts, like brushes, ball bearings,
gears etc. or others, must be carried out only by an authorized customer-
service workshop or on www.rupes.com.
Use only the original RUPES parts or accessories.
DISPOSAL (WEEE DIRECTIVE)
For EU countries only: According to the European Directive on
Waste from electrical and electronic equipment and its implementa-
tion in conformity with national standards, exhausted electrical
equipment must be collected separately, in order to be recycled in
an environmentally friendly way. The product, when it reaches the end of its
life, must not be dispersed in the environment or thrown away as household
waste. It must be disposed at authorized recycling centres (contact your lo-
cal authorities to know where to dispose of the product according to the law).
The correct disposal of the product contributes to the health and preserva-
tion of the environment.
Illegal disposal of the product will entail penalties against the offenders.
EU DECLARATION OF CONFORMITY
We declare on our responsability that the hand-held motor operated tool,
which is mentioned in the present operating manual, is in comformity with
the Essential Requirements of the following Directives:
2006/42/EC; 2014/30/EU; 2011/65/EU.
The tests have been carried out in accordance with following Standards:
EN 62841-1:2015 + AC:2015
EN 62841-2-17:2017
EN 55014-1:2017 + A11:2020
EN 55014-2:2015
EN IEC 61000-3-2:2019
EN 61000-3-3:2013 + A1:2019
EN IEC 63000:2018
Technical file at:
RUPES S.p.A. a socio unico
Via Marconi, 3/A - Loc. Vermezzo
20071 Vermezzo con Zelo (MI) - ITALY
Vermezzo con Zelo (MI), 15/06/2022
S.p.A. a socio unico
IL PRESIDENTE
G. Valentini
13