Publicité
Les langues disponibles
Les langues disponibles
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any length of time during this
process, it must be allowed to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove both leveling legs located at the front of the cabinet. Se
2. Remove the screws holding the lower hinge assembly to the cabinet. See
ure A.
3. Remove the door from the cabinet by lifting the door slightly and then
pulling downward.
4. Usin
t head screwdriver, remove the upper hinge pin from the worktop
and install it on the opposite side of the cabinet. Se
5. Remove the hole plug from the top left side of the door and the bushing
from the top right side of the door and swap their positions. Do the same with
the hole plug and bushing on the bottom of the door. Se
6. Install the door on the cabinet. Ensure that the top of the door is level with
the top of the cabinet and that the rubber gasket makes a good seal with the
cabinet all the way around.
7. Install the lower hinge assembly on the opposite side and then install both
leveling legs.
A
ure B.
B
ure A.
ure B.
Publicité
