Read this first!
WARNING
■
Do not remove any screws other than those indicated when replacing the lamp
unit.
•
If this is not observed, electric shocks, burns or other injuries may occur.
■
Wait until the lamp unit has cooled sufficiently before replacing the lamp unit
(wait one hour or longer).
•
The lamp cover gets very hot, and contact with it can cause burns.
■
Remove the power plug before replacing the lamp unit.
•
If the lamp unit is replaced without removing the power plug, electric shocks and breakage may occur.
Notes on replacing the lamp unit, air filter, and electrostatic filter
•
A Phillips screwdriver is necessary when carrying out replacement.
Hold the screwdriver firmly.
The light source lamp is a glass component. If it is hit on a hard object or dropped, breakage may occur.
•
Be careful when handling a light source lamp.
Do not disassemble or modify the lamp unit.
•
Grip the handle when you remove the lamp unit. Some parts of the lamp unit are sharpened and may cause injury.
•
The lamp may be ruptured. Care should be taken not to scatter pieces of the broken lamp glass when replacing the lamp
•
unit. Pieces of the broken lamp may fall from the lamp unit especially when the projector is mounted on the ceiling, so when
replacing the lamp unit do not stand directly underneath it or position your face close to it.
•
The lamp contains mercury. Contact the local government office or distributor for the correct disposal of the old lamp unit.
Illustrations in these operating instructions
•
Illustrations contained in these operating instructions that show the projector and screens may differ from the actual objects
they depict.
NOTICE
For USA only
Hg-LAMP CONTAINS MERCURY, Manage in Accord with Disposal Laws.
See: www.lamprecycle.org or 1-888-411-1996
Accessories
The following accessories (2 x filter/bagged) are included.
Air filter (black) x 1
Electrostatic filter (white) x 1
Attention
Dispose of the packaging materials properly after unpacking the product.
•
2-ENGLISH
Always follow these precautions