Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Thank you for purchasing this Panasonic product.
Please read these operating instructions and the projector operating instructions carefully, and then use this product
correctly.
Before using this product, be sure to read "Read this first!" (Page 2).
Please save this manual for future use.
Disposal of Old Equipment
Only for European Union and countries with recycling systems
This symbol on the products, packaging, and/or accompanying documents means that used electrical and
electronic products must not be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take them to applicable collection points in
accordance with your national legislation.
By disposing of them correctly, you will help to save valuable resources and prevent any potential negative
effects on human health and the environment.
For more information about collection and recycling, please contact your local authority.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
EEE Yönetmeliğine Uygundur.
EEE Complies with Directive of Turkey.
Operating Instructions
Model No.
Replacement lamp unit
ET-LAA110
TQZJ394-3

Publicité

loading

Sommaire des Matières pour Panasonic ET-LAA110

  • Page 1 Operating Instructions Replacement lamp unit ET-LAA110 Model No. Thank you for purchasing this Panasonic product. • Please read these operating instructions and the projector operating instructions carefully, and then use this product correctly. Before using this product, be sure to read “Read this first!” (Page 2).
  • Page 2 Read this first! Always follow these precautions WARNING ■ Do not remove any screws other than those indicated when replacing the lamp unit. • If this is not observed, electric shocks, burns or other injuries may occur. ■ Wait until the lamp unit has cooled sufficiently before replacing the lamp unit (wait one hour or longer).
  • Page 3 Replacing the lamp unit, air filter, and electrostatic filter Attention • If the projector is operating, turn off the power by the following procedure and wait for the lamp unit to cool down before carrying out replacement. Press the power < >...
  • Page 4 4 catches are properly aligned with the protrusions on the air filter case and they have clicked into place. Panasonic Connect Co., Ltd. Web Site : https://panasonic.net/cns/projector/ TI0911AM3042 -PS © Panasonic Connect Co., Ltd. 2022 Printed in China...
  • Page 5 Mode d'emploi Lampe de rechange ET-LAA110 Modèle № Merci d'avoir acheté un produit Panasonic. Veuillez lire ce mode d'emploi ainsi que le mode d'emploi du projecteur soigneusement afin d'utiliser ce produit • correctement. • Avant d'utiliser ce produit, veuillez lire la section « Lire ces informations en premier ! » (page 2).
  • Page 6 Lire ces informations en premier ! Toujours suivre les précautions ci-dessous AVERTISSEMENT ■ Lors du remplacement de la lampe, ne pas enlever de vis autres que celles indiquées. • Vous risquez sinon de subir des chocs électriques, des brûlures et d'autres blessures. ■...
  • Page 7 Remplacement de la lampe, du filtre à air et du filtre électrostatique Attention Si le projecteur est en marche, arrêter l'alimentation en suivant la procédure suivante et attendre que la lampe refroidisse • avant d'effectuer le remplacement. Appuyer sur le bouton d'alimentation < >.
  • Page 8 Veiller à installer la lampe et le couvercle de la lampe situés sur le boîtier du filtre et qu'elles se soient bien correctement. emboîtées dans les ergots. Panasonic Connect Co., Ltd. Web Site : https://panasonic.net/cns/projector/ TI0911AM3042 -PS © Panasonic Connect Co., Ltd. 2022 Printed in China...