Lampa AMPEROMATIC DIGIT PRO Manuel D'utilisation page 8

be possible to select other types of mode), this modality cannot be interrupted during the process and it will charge
until it reachs 14.4V, then it will stop the process automatically. Lithium batteries cannot undergo any float charging
when they reach the maximum level of charge, since the battery may explode or burn.
For LFP batteries there is any float charging process, the charging process will re-start once the battery level will drop
below 13.0V.
For AGM charging mode, floating process will start once max. voltage reachs 14.7V.
Safety warning: do not interrupt the desulphurization process. But if required, you can disconnect the plug of the
battery charger in order to stop the process.
The desulphurization setting is the same for AGM, STD, GEL, etc.
ERROR
Polarity inversion – If the clips are not properly connected to the poles, the
mend you to disconnect the plug and to properly connect the poles to the battery, then reconnect the plug (230V)
again.
Characteristics:
• Full protection against spark formation
• Protection against short circuit
• Voltage compensation
• Overheating protection
• Polarity inversion protection
SAFETY INSTRUCTIONS
In order to prevent you from damages, injuries, short circuits or fires due to the use of the battery charger, be sure that
you properly follow the standard safety instructions below. We recommend you to read the following instructions
carefully before using this product and to store them for future reference.
ATTENTION:
Keep this product out of reach of children.
• Be careful to short circuits: do not use this product near or proximate to warm areas or objects.
• Professional technical use: use this product in closed areas, do not use this product in steamed or damped areas.
Use this product in light environment but not under the direct sunlight, warm areas, snow or rain.
• Clothing: we recommend you to wear technical clothes that cannot obstruct the movements while operating with
this product, moreover we recommend you not to wear pieces of jewelry while using this product, this way you will
avoid the contact between the battery and the battery charger.
• Battery charger care: when not in use, we suggest you to store the battery charger in a dry place, at room
temperature and out of the reach of children. Technical professional usage exclusively.
• Cable protection: it is strongly forbidden to hold or take the battery charger from the cable side or to unplug the
device by pulling the cable. Keep out the cable from sharpened objects, hot areas or oils that can damage it.
• Battery charger unplug: when not in use, we recommend you to unplug the device.
• Check the evidence of damages: before using it, we recommend you to check the battery charger, the cable and the
clips in order to detect any kind of damage.
• Product repairing: for every kind of product every repairing, we recommend you to have it repaired from
professional technical staff. Do not try to force and open the battery charger body. If the clips or the cables should
be damaged, replace them before using the battery charger.
• Gas: while charging the battery, bubbles can form inside the liquid, which is due to gas formation. This kind of gas
is highly inflammable, therefore we suggest you to avoid making flames while charging the battery and to keep
ventilated the area. In order to avoid the risks of explosion, we recommend you to remove the elements of the
battery before connecting the plug to the power, viceversa we recommend you to put back the elements for the
battery after having disconnected the battery charger from the power.
WARNING
DO NOT TOUCH THE ELECTROLYTES WITHOUT PROPER PROTECTIVE CLOTHES. IT IS ACID AND IT CAN CAUSE BURNS.
SHOULD YOU TOUCH THE ACID AND GET BURNED, WASH THE INJURED AREA WITH WATER IMMEDIATELY.
1. Before charging the battery, be sure that you are using the proper input, otherwise it can cause damages to the
battery charger or affect its performances.
8
symbol will light on. We recom-