Publicité
Les langues disponibles
Les langues disponibles
3. Coupling assembly (Fig. D)
WARNING! If you fasten the couplings
onto a vertical brace, make sure that
other cross-braces or fasteners are above
it in order to prevent the product from
sliding upward. Horizontal braces are
suitable for optimal placement of the
product.
1. Set the plastic strap (3a) around the frame of
the pram/buggy.
2. Insert the end of the plastic strap through the
opening of the clasp (3b).
3. Tighten the coupling by turning the coupling
screw (3c).
Note: make sure that the pram/buggy can be
folded together without difficulty. Otherwise
mount the couplings at another spot.
4. Fasten the other coupling in the same way.
Important! The couplings must be firmly
attached to the frame so that there is no room for
movement and they do not move.
4. Connecting the coupling (Fig. E)
1. Press the flip switch (4a)/(5a) of the extension
(4)/(5) to open the clasp.
2. Connect the hook (4b)/(5b) with the coupling
screw (3c).
3. Press the hook back into the clasp.
Note: when connecting the hook make sure
that the blocking pin (4c)/(5c) of the extension is
pointing downward.
5. Setting the width (Fig. F)
1. Loosen by pulling the latch (1b) on the front
part of the product.
2. Pull the sides of the product to the desired
width.
3. Let the latch lock tightly and audibly.
6. Setting the length/connecting the
product (Fig. G)
1. Push the extensions (4)/(5) into the sides of the
buggy board.
2. Audibly lock the blocking pins (4c)/(5c) into
one of the holes.
Note: the product has four holes on the under-
side for setting the length.
Set the product as close to the pram/buggy as
possible so that the child can stand comfortably
and hold onto the push handle.
7. Tilting up during non-use and for
better accessibility of the locking
brake (Fig. H)
If the product is not in use and for easier access to
the locking brake, you are able to tilt it up:
1. Loosen the coupling screw (3c) if necessary.
2. Fold the standing surface of the product up-
ward.
3. Connect the hook (6) to the edge of the stand-
ing surface and fasten the string on the push
handle of the pram/buggy.
Important! Always remove the string with the
hook (6) when the pram/buggy is not in use.
Disassembly
Important! Do not fold up the pram/buggy with
the product attached.
Proceed as follows to remove the product from the
pram/buggy:
1. Push the flip switch (4a)/(5a) of the extensions
(4)/(5).
2. Pull the hooks (4b)/(5b) from the coupling
screws (3c) and remove the buggy board (1).
3. Leave the couplings on the frame.
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature.
Clean only with water and wipe dry afterwards
with a cloth.
IMPORTANT! Never clean the product with harsh
cleaning agents.
Disposal
Dispose of the article and the packaging materials
in accordance with current local regulations.
Packaging materials such as foil bags are not sui-
table to be given to children. Keep the packaging
materials out of the reach of children.
Dispose of the products and the
packaging in an environmentally friendly
manner.
The recycling code is used to identify
various materials for recycling. The code
consists of the recycling symbol – which is meant
to reflect the recycling cycle – and a number
which identifies the material.
GB/IE/NI
9
Publicité
