Fanelite CR-66516SP Mode D'emploi Et D'utilisation page 31

5. ASSEMBLY
1. Insert the pillar into the hole in the center of the base then secure it by
tightening the nut under the base (base/tube assembly mechanism)
2. Install the second pillar to the first pillar as below, please pay attention
to the alignment. For the table version, use only one pillar.
3. Install the handle on the fan head.
4. Place the rear grille on the motor block, taking care to align the notches
on the grille with the 2 lugs on the motor block.
5. Tighten the rear grille lock nut clockwise.
6. Align and place the blade onto the shaft of the motor until it locks in
place.
7. Then secure it by tightening the blade locking nut counter-clockwise.
Be sure to tighten the nut properly. Check that the blade turns well by
turning it manually.
8. Place the front grille on the rear grille and assemble the grilles using
the hoop.
31