Publicité
Les langues disponibles
Les langues disponibles
•
Either decommission the warning light or do not use it when it is damaged.
•
Only use the warning light under the environmental conditions for which it is specified.
Deviating environmental conditions can contribute to damage to the equipment and may
E
lead to possible danger to the life of the user.
•
Do not use the warning light at temperatures deviating from the specified ambient
temperature range.
•
Follow all instructions written on the equipment and as mentioned in this manual.
•
Repairs may only be carried out by the manufacturer or by a person appointed by the
manufacturer.
•
Modifications to the equipment or changes to the design are not permitted.
•
The product may only be used for the function for which it is designed and shall be
maintained in a good and clean condition.
If these instructions are not followed, the explosion safety of the equipment cannot be
guaranteed. The equipment could then endanger the life of the user and could cause the
ignition of an explosive atmosphere. Consequently, Artidor as the manufacturer will waive
any responsibility.
3.
Characteristics
The characteristics of the LED warning light can be summarized as follows;
•
Robust warning light with a very low height of only 41 mm
•
Stainless steel AISI 316 or anodized aluminum housing
•
Obtainable in three colored lights enabled by the use of colored LEDs
•
Continuous lighting or blinking mode, user selectable
•
Provided with a fixed cable
•
Manufactured on the basis of the European Directive 2014/34/EU (ATEX 114)
•
Suitable for use in gas and dust hazardous areas classified as zone 1, 2, 21 and 22
•
Explosion safety category and protection degree against ignition applied:
II 2 G Ex mb IIC T4 Gb
II 2 D Ex mb IIIC T135°C Db
•
Protection degree against the ingress of water and dust IP65
•
Suitable for internal and external use
•
Mounting position 360°
Installation manual AR-048 LED warning light
6 / 36
05-2024
Publicité
