Baldwin RESERVE 47039-004 Guide D'installation

47039-004 Rev 04 Single Cylinder Deadbolt
Door Thickness
If the door thickness was specified at the time lockset was ordered, the
package will contain the hardware required for the specified door
thickness. If the door thickness was NOT specified, the package will
contain hardware that fits 1-3/4" - 2" (44 mm - 51 mm) thick doors.
Thick and thin door installation kits need to be purchased separately.
Service kit installation instructions are available online at
baldwinhardware.com
Thin doors
Between 1-3/8" and 1-3/4"
(35 mm – 44 mm)
1. Adjust and install latch
Measure your door backset as shown.
If backset of door measures 2 3/4" (70mm),
adjust latch by rotating face as shown.
LATCH FACE ASSEMBLY
For Drive-In Latch
Remove backplate.
WARNING: This manufacturer advises that no lock can provide complete
security by itself. This lock may be defeated by forcible or technical means,
or evaded by entry elsewhere on the property. No lock can substitute for
caution, awareness of your environment, and common sense. Builder's
hardware is a available in multiple performance grades to suit the application.
In order to enhance security and reduce risk, you should consult a qualified
locksmith or other security professional.
TEMPLATE
Door Preparation
If your door requires drilling, use the
supplied template with the door
preparation instructions available at
baldwinhardware.com
Thick doors
Between 2" and 2-1/2"
(51 mm – 64 mm)
Snap on collar.
Borde Champ
Edge
LATCH INSTALLATION
U P
Ensure the latch is inserted
with the word "UP" on top.
For Square Corner/
Round Corner
OR
Install with 1/2" (13 mm) screws.
2. Install Trim
Only use if
included in the box
3. Install Strike
Frente Face
Face
Fold
Doble
Plier
Centerline
Linea central
Ligne médiane
2-3/8" (60 mm)
2-3/4" (70 mm)
Backset
Distancia al centro
Écartement
Copyright © 2023 ASSA ABLOY Americas Residential Inc. All rights reserved.
Installation Guide
BALDWINHARDWARE.COM
Note, for a 1-1/2" (38 mm) diameter
hole, test if latch extends and
retracts. Chisel out area if required.
UP
For Drive-In Latch
Drive in with hammer.
Please note: Product illustrations may differ
from your product. Installation is the same.
1/8" (3 mm) pilot
holes may be required.
800.566.1986