Publicité
Les langues disponibles
Les langues disponibles
9.2
REPLACE THE BLADE
17
WARNING
Use only approved replacement blades.
WARNING
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the blade nut (19) and spacer (18) with a impact
wrench or socket.
7. Remove the blade (17) and the positioner (21).
8. Position the new blade with the cutting edges toward the
ground .
9. Put on the blade nut and spacer, and tighten them with the
impact wrench.
9.3
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure that the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person of an approved service center.
•
Store the machine in a dry area.
English
21
19
18
•
Make sure that children cannot come near the machine.
10
TROUBLESHOOTING
Problem
Possible cause
The handle is not
The bolts are not
in position.
engaged correctly.
The machine does
The battery ca-
not start.
pacity is low.
The handle switch
is defective.
The battery key is
not put in.
The machine cuts
The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
There is a high vi-
The blade is un-
bration in the ma-
balanced and
chine.
worn.
The motor shaft is
bent.
13
EN
Solution
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Charge the battery
pack.
Replace the handle
switch.
Put in the battery
key.
ing area.
Move the wheels
to a higher posi-
tion.
Increase the blade
height.
Empty the grass
clippings from the
grass catcher.
Replace the blade.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.
Publicité
