HAEGER Dehumidifier 16 Mode D'emploi page 8

English
(%).When you first use the dehumidifier, the humidity control is by default to
50%.
- Allow at least 24 hours for the dehumidifier to achieve the humidity level. If
you still have damper air than desired, set the humidity level to a lower
setting or select Continuous for maximum dehumidification.
- After a period of working, when the environment humidity is lower than the
selected humidity by 5%, the compressor will stop and fan stops working
after a presetting time later. When the environment humidity is equal to or
higher than the selected humidity by 5%, the compressor will restart once
the preset compressor protection time is over.
-
Humidity Setting & Timer Indicator display
In dehumidifying, it will indicate the actual room humidity. In timing
mode, it indicates the setting time.
-
Fan speed button / Internal drying function
Set the fan speed to
humidity has been reduced and quiet operation is preferred, set the fan
speed to
Long press for 5 seconds to start the inside drying function.
-
Timer button – 24 hours timing / Ionizer (optional)
Press the key, to set the timing off or timing on, timing range is from 1 to
24hours, it will increase 1hour by each press. Press the key again to cancel.
Turning off
When unit is working, press Timer button to start the function, then press
UP/DOWN button to set hours from 1 to 24hours. When time is up to your
setting, unit will turn off. After setting, timer button flashes 5 times for
confirmation.
Turning on
When unit is in standby (power on), press Timer button to start the function,
then press UP/DOWN button to set hours from 1 to 24hours. When time is up
to your setting, unit will turn on. After setting, timer button flashes 5 times for
confirmation.
Ionizer
– Long press for 3 seconds to start or shut off the function.
6
for maximum moisture removal. When the
.
Instructions for use