Star ULTRA-MAX 802H Instructions D'installation Et D'opération page 7

PILOT LIGHTING INSTRUCTIONS
The hotplate is equipped with factory pre-set standing pilots and should be lit
immediately after the gas is turned on. Pilot lights may need an adjustment based on local
gas supplies. See below for pilot light adjustments.
If the operator smells gas or the pilot lights need to be relit:
1. Turn off main valve to unit.
2. Turn off all knobs and pilot valves and wait 5 minutes to clear gas.
3. The pilot lights on this hotplate can be adjusted by turning the adjustable screw
counterclockwise to open and clockwise to close.
4. Turn on main valve and light all pilots.
5. Adjust pilot light flames as small as possible around pilot head, usually about 1/4" high,
but high enough to light burner immediately when burner valve is turned on high.
6. Turn burner knobs to desired setting.
7. To turn burners off, turn knobs clockwise to "OFF."
If interuption of the gas supply occurs, reliting of the pilot light will be needed.
BURNER IGNITION AND ADJUSTMENT
1. To ignite burners turn burner valve knob counter clockwise to "ON"position.
2. Slowly decrease openings of air shutters to give a soft blue flame having luminous tips,
then slowly increase openings to a point where the yellow tips disappear and a hard blue
flame is obtained.
LIGHTING
When hotplate is first lit, it may smoke for approximately 20-30 minutes until the preservation
oils and impurities are burned off.
OPERATING INSTRUCTIONS
BOTTOM CRUMB PAN
The crumb pan is located at the bottom of the unit, and is easily removed from the front of the
unit for cleaning. Be sure it is in place during operation.
BURNER OPERATION
Each burner is controlled by an individual on-off valve. A variety of temperatures may be
obtained by turning the burner valve knob to any position between ON and OFF. It is possible
through this arrangement to have a high heat section, while having a low heat simmering or
holding section. For the high heat operation, turn the valve counter clockwise for the section
to a position of ON or close to it. For holding or simmering, turn the valves closer to the
OFF position on the dial. If even less heat is required, the valve may be turned OFF and the
product kept warm on the pilot flame. You select the heat pattern you like and set the valves
accordingly. Be sure burners are staying fully lit when set in low positions.
COMPLETE SHUTDOWN INSTRUCTIONS
Turn the burner valve knobs to the OFF position to turn burners off and close manual valve
gas shutoff.
CLEANING
Clean regularly. Be sure appliance has cooled down. Remove grate section and burner head
to sink for washing. Brush out carboned particles. Venturi must be free from grease, dirt,
lint, or any foreign material. Remove and wash crumb pan. Be sure to replace top grates
laying flat and centered over the burner. Wipe exterior surfaces with a mild detergent and
a cloth. A non-abrasive cleaner can be used on caked areas. Be careful with spraying on
some cleaners as they may contain abrasives and caustics which could scratch or damage
the finish.
8