Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LEVELING UNIT
This hotplate is supplied with 4 feet or floor stand
legs which must be screwed into the body. Unit must
be level. Level unit by adjusting the (4) feet which
have an adjustment of 1-3/4" for accurate and perfect
line-up with other units.
Caster Kits: Casters can be used with floor stand models or optional equipment stand. For installation, carefully
mark and cut off from the bottom of each leg using a straight cutting saw and de-burr the inside tube wall prior
to installing the caster. Cut leg should measure 19" tube length, not overall length. On SFC models only, use
kit number ES-UM36SFC. Casters add about 6-1/4" of height to the unit. Be sure to use approved strain relief
means for protecting gas line connection. If an appliance is equipped with casters and is gas connected with a
quick connect coupling, all personnel must be aware that there is a restraint on the appliance and if disconnected
for service or cleaning it must be reconnected as originally installed prior to use.
CAUTION
DO NOT INSTALL WITHOUT ATTACHING
FEET OR SUPPLIED STAND LEGS AND
SHELF - DO NOT REMOVE FEET.
6
Publicité
Table des Matières
