ChefLine CHFC728 Manuel D'utilisation page 10

Operation
How to switch the unit from Stand-By Mode to ON / How to switch the unit from ON to Stand-By mode
Press and hold the ON/OFF key
•
Note: the icon will be displayed for a few seconds as below figure and then the display will go off.
The icon will be displayed again when one of the keys is pressed.
How to Lock and Un-lock the keyboard
• For un-lock the controller press any key for more than 2s. The display shows "
keyboard is unlocked.
• For lock the controller don't press any key for 1 minute. The display shows "
keyboard is lock.
How to see the set point
• Push and immediately release the
• Push and immediately release the
How to change the setpoint
• Push the key (Fig.N.1), the value of temperature setpoint appears with the available range (Fig.N.2)
• To change the temperature set value push the "
• To memorize the new temperature setpoint push the
setpoint appears with the available range (Fig.N.3).
• To change the humidity set value push the "
key.
GB
for 3s.
key, the set point is displayed.
key or wait about 5s to return to normal visualisation.
" (Up) or "
"(Up) or "
• To exit the procedure push ON/OFF key
9
"to indicate that the
" to indicate that the
" (Down) arrows.
key again. After confirmation humidity
"(Down) arrows and confirm by press
P2M072STD-Ver1.0
or wait 5 sec.