Publicité
Les langues disponibles
Les langues disponibles
Installing side grip (handle)
012908
012911
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Remove one of the screws which secure the head cover.
Then, screw the side grip into the screw hole.
Installing pad and abrasive disc
1
2
3
012909
Remove all dirt or foreign matter from the pad.
Screw the pad onto the spindle with pressing the shaft lock.
Attach the abrasive disc on the center of the pad. Pay
attention that the pad is placed inside of the edge of the
abrasive disc.
012910
To remove the abrasive disc, peel off its edge from the
pad.
1. Screw
1
1. Abrasive disc
2. Pad
3. Spindle
WHEN USING AS A GRINDER
When using the tool as a grinder, remove the head cover
and install the side grip and an optional wheel guard.
012906
1
012907
Loosen the screws and remove the head cover.
012724
Screw the side grip securely on the position of the tool
as shown in the figure.
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Installing or removing wheel guard
(For depressed center wheel, multi-disc, wire
wheel brush / abrasive cut-off wheel, diamond
wheel)(Optional accessory)
WARNING:
When using a depressed center wheel, multi-disc
•
or wire wheel brush, the wheel guard must be fitted
on the tool so that the closed side of the guard
always points toward the operator.
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels.
8
1. Head cover
2
2. Gear housing
Publicité
