Peppa Pig 446529 2307 Notice D'utilisation page 4

• Do not let your child use the product unsuper-
vised as children cannot adequately assess
potential dangers.
• Using the product requires skill to prevent falls
or collisions, which could result in injury to the
user or others.
• No modifications may be made to the product!
• Non-replaceable LED.
Preventing damage
to the product!
• Avoid water, oil, potholes and very rough
surfaces.
Assembly (Fig. B)
The product is delivered in two parts. Assemble
as follows:
• Take the product out of the packaging, press
the locking pin (3) and insert the handle-
bar (2) into the Tri-Scooter base (1).
Important: Make sure that the
handlebar locks into place in the
Tri-Scooter base. Caution! Risk of
pinching!
Adjusting the height of the
handlebar (Fig. C)
The handlebar can be adjusted to three
different heights. The product may only
be used if the locking knob is locked in
place in one of the three holes provided
and the T-tube is then secured using the
quick-release fastener.
1. Loosen the quick-release fastener (4) on the
handlebar (2).
2. Pull the T-tube (5) upwards, until the locking
knob (6) locks into place in one of the three
holes (7).
3. Tighten the knurled screw (8) by hand.
4. Secure the T-tube (5) by locking the quick-re-
lease fastener (4).
Note: if the quick release fastener (4)
does not fit snugly on the handlebar (2)
when tightening, tighten the knurled
screw (8) firmly with a hex key.
Make sure that the quick release fasten-
er (4) is secured before tightening.
4 GB/IE/NI
Disassembly
Press the button (3a) on the left side of the
tri-scooter's base and pull out the handlebar (2)
(Fig. B).
Use
Riding
• Put one foot on the deck and give momentum
by regularly pushing off with the other foot.
• The Tri-Scooter can be steered by moving the
handlebars, by shifting your weight or using a
combination of both.
Maintenance
Replacing the front wheels
The front wheels can be replaced.
Important! Pay attention to the tech-
nical specifications. Wheels with a
different diameter may alter the riding
properties and possibly endanger the
user. Do not use wheels that cannot be
installed properly. Never use wheels
that are larger than the original wheels
on the product.
Wheels wear out. This wear depends on many
factors, including the terrain, the size and weight
of the user, the weather conditions, the material
of the wheels and their hardness, etc. Therefore,
it is necessary to replace them now and then.
1. Use a suitable hex key (not included in the
package contents) to loosen the screws on the
two front wheels.
2. Install the new wheels and secure them with
the screws.
After replacing the wheels:
After the first few minutes of riding,
make sure that the screws are still
tight and that nothing has detached or
become loose. Tension the wheel once
more to make sure that it runs smoothly.