Publicité
Les langues disponibles
Les langues disponibles
5. Thread the extension pole nut onto thread of the inner pole.
6. Take the fan motor housing and insert into the inner pole. Tighten the neck set screw.
(Refer to Fig. 7)
7. Remove four mounting screws from the motor housing where indicated to use for
rear guard, then assemble rear guard onto the motor housing using with screws.
Tighten the 4 screws securely. (Refer to Fig. 8. and Fig 9)
8. Place fan blade onto the motor shaft. Tighten the blade by the set screw securely on
flat surface on motor shaft. (Refer to Fig. 10)
9. Attach the front guard to rear guard with hook clip centered on the top above wire
handle. Press remaining guard clips onto rear guard to securely attach the front
guard. Do not operate the fan without the guard in place. (Refer to Fig. 11 and Fig. 12)
Fig. 7
Fig. 10
Fan speed: Use the fan switch at the back of the fan to set to Low, Medium or High
setting.
NOTE: It is normal for the motor to feel warm to the touch after continuous operation.
This fan features a safety thermostat that will automatically shut off it the event that
the fan reaches 135°C. If this were to happen, unplug the fan from the electric outlet
immediately.
Oscillation Control: Control the fan oscillation by pressing the rocker switch on the fan
motor housing.
Height Adjustment: Loosen the knob on the extension pole, adjust the desired height
and tighten the knob.
Vertical Tilt: Adjust the fan head.
Fig. 9
Fig. 8
Fig. 11
OPERATION
-4-
Fig. 12
Publicité
