miniland humitop Mode D'emploi page 11

5.2. PRECAUTIONS FOR USE
1. Do not fill the water tank (3) with water whose temperature is in excess of 40 °C to
avoid discolouring or deforming it.
2. Do not allow water to enter the interior of the body of the device by means of the air
outlet. Dry and water from the exterior part of the base with a dry cloth.
3. Do not insert metals, chemical substances, or detergents into the water tank,
because these actions could cause the release of vapour to be affected.
4. If the water tank is excessively full, do not move the device - the water could spill
over and come into contact with the interior of the body of the device, which could
cause damage to some internal components.
5. Never empty the water which remains in the hollow of the base without having first
turned off the device - the transducer would burn itself out immediately.
5.3. TROUBLESHOOTING:
SYMPTOMS
The humidifier
does not work; it
releases neither
air nor vapour
The vapour has
an unpleasant
smell.
The empty
water tank
warning
illuminates with
a red colour,
but the water
tank is full
Only a little
vapour comes
out of the
nozzle
Strange noise
Other
operational
failures
CAUSE
It has not been connected
to the power supply
The humidifier has not
powered on
The water tank is empty
The humidifier is new
The water is dirty or has
been stored in the water
tank for a long time
The water tank is too full
The water tank has not
been correctly positioned
on the base
There is only a little water
remaining in the water
tank
The transducer is dirty
Vibration of the surface
upon which the humidifier
has been placed
There is only a little water
remaining in the water
tank
Get in touch with the Miniland technical service personnel
ACTION
Connect the humidifier to the mains
network
Power on the unit by pushing the
button
Fill the water tank
Open the water tank and air it off in
a cool, dry place for twelve hours
Clean the water tank and fill it with
clean water
Empty the water tank a little and
put it back in position
Remove the water tank and put it
back in position correctly. Check
that some air bubbles appear when
placing the water tank on the base
Fill the water tank with water
Clean the transducer following
the instructions in point 6 of this
instruction manual
Place the humidifier on a flat and
stable surface
Fill the water tank with water
11
ENGLISH