Page 1
Trestle Collection | Model 424122 NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. Need help? Visit Sauder.com to view video assembly tips or chat with a live rep. PLEASE READ AND KEEP FOR FUTURE REFERENCE. Prefer the phone? Call 1-800-523-3987.
Page 2
Assembly Tools Required Part Identifi cation No. 2 Phillips Screwdriver Tip Shown Actual Size Hardware Identifi cation Assembly Steps 5-16 Hammer Not actual size Français 17-18 Español 19-20 Skip the power trip. Safety 21-22 This time. Warranty Page 2 424122 www.sauder.com/services...
Page 3
UPPER CENTER SHELF (1) LOWER CENTER SHELF (1) BOTTOM SHELF (1) BACK (5) RIGHT FRONT LEG (1) LEFT FRONT LEG (1) RIGHT REAR LEG (1) LEFT REAR LEG (1) SKIRT (2) LEFT SIDE SKIRT (1) RIGHT SIDE SKIRT (1) www.sauder.com/services 424122 Page 3...
Page 5
SKIRTS (M and N) and SKIRTS (L). Then, insert the metal end of a CAM DOWEL (2F) into each HIDDEN CAM. Do not tighten the HIDDEN CAMS in this step. Arrow Arrow Insert the metal end of the CAM DOWEL into the HIDDEN CAM. (8 used) www.sauder.com/services 424122 Page 5...
Page 6
Push thirty HIDDEN CAMS (1F) into the holes of the TOP å SHELVES (B, C, D, E, and F) and BACKS (G). Arrow (30 used) Arrow Hole The arrow in the HIDDEN CAM must point toward the hole in the edge of the board. Page 6 424122 www.sauder.com/services...
Page 7
Step Step 3 Turn thirty CAM SCREWS (8F) into the LEGS (H, I, J, and K). å (30 used) These holes will not have CAM SCREWS. These holes will not have CAM SCREWS. www.sauder.com/services 424122 Page 7...
Page 8
NOTE: Start each screw a few turns before completely å (and snacks) required. tightening any of them. SILVER 1-1/8" FLAT HEAD SCREW Surface with HIDDEN (8 used in this step) CAMS must be facing up. Edge with CAM DOWELS Finished edge Page 8 424122 www.sauder.com/services...
Page 9
H I D D E N S u r f a c w i t h H I D D E N S u r f a c w i t h H I D D E N www.sauder.com/services 424122 Page 9...
Page 10
D E N f a c H I D S u r w i t h D E N H I D f a c S u r w i t h D E N H I D Page 10 424122 www.sauder.com/services...
Page 11
Fasten the LEGS (I and K) to the SHELVES (B, C, D, E, and F) å and BACKS (G). Tighten fi fteen HIDDEN CAMS. NOTE: Be sure the METAL PINS (1R) in the ends of the å BACKS (G) insert into the holes in the LEGS (I and K). www.sauder.com/services 424122 Page 11...
Page 12
NOTE: There are no pre-drilled holes in the back of the å leave without a bite. SHELVES (B, C, D, E, and F). Use extra force when turning these screws. BLACK 1-1/4" FLAT HEAD SCREW (10 used in this step) Page 12 424122 www.sauder.com/services...
Page 13
Tighten Risk of damage or Arrow injury. HIDDEN CAMS must be completely Arrow Maximum tightened. HIDDEN 210 degrees CAMS that are not completely tightened may loosen, and parts may separate. To Minimum completely tighten: 190 degrees www.sauder.com/services 424122 Page 13...
Page 14
Step 10 Fasten the SKIRTS (L) to the TOP (A2) and BOTTOM (F). å Tighten four HIDDEN CAMS. Maximum Arrow 210 degrees Minimum 190 degrees Surface with HIDDEN CAMS Surface with HIDDEN CAMS Page 14 424122 www.sauder.com/services...
Page 15
HIDDEN CAM except on the bottom of the SHELF (F) and lower SKIRT (L) as noted below. (8 used) To cover SILVER screws (32 used) To cover HIDDEN CAMS Do not cover HIDDEN CAMS here. www.sauder.com/services 424122 Page 15...
Page 16
This completes assembly. Clean with a damp cloth. Wipe dry. å Washer And to celebrate, why not share your success story? Safety drywall 15 lbs. anchor Safety strap 25 lbs. 25 lbs. 30 lbs. 30 lbs. 40 lbs. Page 16 424122 www.sauder.com/services...
Page 17
Modèle 424122 Bibliothèque avec 5 Tablettes Utilisez les instructions d’ a ssemblage en français avec les NOUS SOMMES LA POUR VOUS AIDER! schémas étape par étape du manuel d’instruction en anglais. Nous faisons de notre mieux pour nous assurer que votre meuble Chaque étape en français correspond à...
Page 18
MÉTAL (1R) situées sur les extrémités des ARRIÈRES (G) dans les sécurité fi gurant sur les pages arrière du manuel d’instructions. trous des PIEDS (I et K). Ceci complète l'assemblage. Nettoyer avec un tissu humide. Essuyer. Page 18 424122 www.sauder.com/services...
Page 19
ESTANTE SUPERIOR ..........1 PASADOR DE EXCÉNTRICO ......8 necesita ponerse en ESTANTE CENTRAL ...........1 BIELA DE EXCÉNTRICO ........30 contacto con Sauder en ESTANTE CENTRAL SUPERIOR ......1 75P CUBIERTA DE EXCÉNTRICO......32 cuanto a esta unidad, refi érase al número ESTANTE CENTRAL INFERIOR ......1 74P CUBIERTA DE TORNILLO ........8...
Page 20
DORSOS (G) se inserten en los agujeros en instrucciones en cuanto a importante información de seguridad. las PATAS (I y K). Esto completa el ensamblaje. Limpiar con un trapo húmedo. Seque con un paño. Page 20 424122 www.sauder.com/services...
Page 21
Les téléviseurs peuvent être un téléviseur. cet eff et. particulièrement lourds. De plus, le poids et l’emplacement du tube image ont tendance à rendre les téléviseurs instables et enclins à tomber vers l’ a vant. www.sauder.com/services 424122 Page 21...
Page 22
Además, el peso y la ubicación del tubo de imagen tienden a causar la inestabilidad de televisores y propensa a volcarse hacia adelante. Page 22 424122 www.sauder.com/services...
Page 23
à compter de la date d'achat la première fois et qui sont signalés à Sauder dans les limites de couverture de la contre tout défaut de matériaux ou de fabrication des composantes de mobilier Sauder.
Page 24
Dear Valued Customer: So, how did it go? Thanks so much for choosing Sauder® furniture. I hope the Set a world record for speed? purchase and assembly process was a positive experience Feeling good about yourself? and you feel good about the furniture you just built. If you Nice.