DeWalt DXSTA500LM Guide D'utilisation

JS PRODUCTS | 6445 MONTESSOURI STREET, LAS VEGAS, NV 89113
(APR18) Part No. 41553
Copyright © 2018 D
D WALT and the D WALT Logo are trademarks of the D
®
E E
Co., or an affiliate thereof and are used under license. The yellow/black color
scheme is a trademark for D
Definitions: Safety Guidelines
The definitions below describe the level of severity for each signal word. Please
read the manual and pay attention to these symbols.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
(Used without word) Indicates a safety related message.
NOTICE: Indicates a practice not related to personal injury which, if not avoided,
may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY
D WALT TOOL, CALL US TOLL FREE AT: 1-844-377-8451
E
WARNING! Read and understand all instructions.
This manual contains important safety and operating
instructions. Please read this manual carefully before
assembling this storage rack and save it for reference.
SAVE THESE INSTRUCTIONS
TECHNICAL SPECIFICATIONS
Technical Specifications
LED
Output
LED Strip Length
DXSTA500LM Copyright © 2018, D
WALT.
E
WALT Industrial Tool
E
WALT power tools & accessories.
E
5630 SMD x 15
500 lm per LED Strip
13.25"
LED Strip Width
LED Strip Height
Sensor Box Length
Sensor Box Width
Sensor Box Height
Sensor Distance
Sensor Timer
Adapter Specs - Input
Adapter Specs - Output
Adapter Cord Length
GENERAL SAFETY
• Keep work area clean and dry.
• Use correct/recommended tools for the job.
• Never leave tools unattended.
• Never force a part into place.
• Wear safety apparel.
• Wear safety glasses/goggles.
• Never crawl, sit, stand, or climb on a rack.
• Keep small parts away from children. Never leave a small child
unattended while assembling.
• Always use common sense – your personal safety is
your responsibility.
Parts List
No. Description
1 LED Strip With Two Magnets
WALT 2 Sensor With Magnet
E
3 Jumper Cord, 3 Foot/1 Meter
4 AC Wall Adapter
5 Velcro
®
1
2
3
BEFORE YOU BEGIN:
• Read all instructions thoroughly.
• Remove all components from the box, and lay them on the floor in an
orderly fashion.
• Wear eye protection.
• Be cautious of sharp edges.
• Keep this information for further reference.
0.875" (1.125" with magnet)
0.75" (1.00" with magnet)
3.625"
2.50"
1.00" (1.25" with magnet)
Up to 10 ft
5 min - 5.5 min auto-off when no
motion is detected
100-240V 50-60Hz
12VDC 3.5A
8 ft
Cord Management Strips
4
5
READ ALL INSTRUCTIONS
Qty.
3
1
3
1
8