L.B. White Tradesman CP400CK Manuel D'utilisation Et D'instructions page 17

MAINTENANCE (cont.)
Pump
Shell Lower
Bracket-Filter
Model CP400CK
Pump Fuel Filter Assembly
Fuel Line(B)
Fuel Filter Shell Lower
Model CP650CK
F F i i g g u u r r e e 2 2 2 2 – – R R e e m m o o v v e e T T a a n n k k F F u u e e l l F F i i l l t t e e r r
Pump Fuel Filter
- Remove fan guard (See Figure 20,21).
- Unscrew filter bottom clockwise from filter top with adjustable
pliers.
- Remove fuel filter, gasket, magnet from filter bottom (See Figure
22).
- Wash filter bottom with clean kerosene.
- Wipe inside of filter bottom dry with clean cloth.
- Wash Fuel filter in clean kerosene.
- Remove dirt attached to magnet.
- Put clean magnet, fuel filter and gasket back in filter bottom.
- Tighten firmly.
Figure 24 – Adjusting Pump Pressure
Screw
Screw
Bracket-Filter
Pressure Gauge Plug
Pressure Gauge
Figure 23 – Fuel Pump Filter
PUMP PRESSURE ADJUSTMENT
- Remove pressure gauge plug from pump with 1/8" Allen wrench.
- Install accessory pressure gauge to pressure gauge port (See
Figure 24).
- Start heater (See Operation, Page 12). Allow motor to reach full
speed.
- Adjust pressure (Using small flat blade screwdriver). Turn pressure
adjustment screw clockwise to increase pressure. Turn screw
counterclockwise to decrease pressure.
- Set pump pressure at 110 PSI (for CP650CK).
- Set pump pressure at 125 PSI (for CP400CK).
- Stop heater (See Operation, Page 12).
- Remove pressure guage. Replace pressure gauge plug in pressure
gauge port.
NOTE: Use only original equipment replacement parts. Use of
alternate or third party components will void warranty and may cause
an unsafe operating condition.
Pressure Gauge Port
Pressure Adjustment Screw
Pump
Filter Top
Gasket
Fuel Filter
Magnet
Filter
Bottom
4 17