Publicité
Les langues disponibles
Les langues disponibles
(1) Top hinge (2) Hinge shaft (3) Hinge buckle (4) Top hinge (5) Lower hinge (6) Glass door
1. As shown in Figure A, use a flat-blade screwdriver to open the top loop of the hinge (3) to see the hinge shaft (2),
then use a flat-blade screwdriver to pull the hinge shaft (2) and remove it. Then unscrew the bottom hinge in the same
way.
As shown in Figure B, the method of installing the upper part of the door is the same as that of the lower
2.
part.
When the top and bottom parts are removed, pull the door parallel to the outside. The door can be removed.
3.
Remove the glass door, use the hex wrench to remove the top door hinge and mounting screws from the
4.
bottom door hinge, and then remove the top and bottom door hinges.
Pay special attention to this:
5.
1) The glass door is rotated 180 degrees to be installed, and the locking hook and door magnet are removed and
reinstalled on the other side.
2) The top hinge and bottom hinge are also exchanged at the same time. The upper right hinge is replaced by the
lower left hinge. The lower right hinge is replaced by the upper left hinge. Becomes the lower hinge of the door
and becomes the top hinge of the door when the lower right hinge is changed to the left side;
First install the door hinge, as shown in Figure C, and then install the bottom hinge as shown in Figure D.
6.
Lift the door as shown in Figure D. First insert the bottom hinge into the corner fittings, align the mounting
7.
holes, and insert the hinge shaft (2) into the hinge hole in position. Next, cover the hinge loop (3). Installation of
the lower part of the door is complete;
Install the top of the door as shown in Figure C, using the same method as the bottom of the installation
8.
door. In the end, the return of the door is complete.
Install the door hinge Note: When installing the top door hinge, please move the door hinge to the side of
9.
the outer case and then tighten the screw. Once the bottom door is installed, move the screw inside the outer casing
and tighten the screw to prevent the door from falling off.
Change the position of the door detector
If you change the direction of door opening, it is important to also change the position of the door
detector:
(1) door (2) magnet: door detector (3) handle
BEFORE
AFTER
43
Publicité
