Prodipe Pro5 v4 Mode D'emploi page 17

3 - Settings
There are different settings on the rear panels of your monitors:
VOLUME
You can adjust the gain setting at the back of the monitor using the changeover switch in (Figure
3). It can be set from -30dB to +6dB.
ADJUSTING THE HIGH FREQUENCIES (HF LEVEL) – Pro5 v4, Pro7 v4 and Pro8 v4 only
You can adjust the high frequencies at the back of the monitor (Figure 4). The possible values are:
-2dB, -1dB, 0dB (flat), or +1dB.
ADJUSTING OF THE LOW-PASS FILTER - Pro10s v4 only
By adjusting the low-pass filter you can set the high cutoff frequency so that the performance of
the subwoofer is optimized relative to your front speakers. The subwoofer audio outputs that
connect to your speakers rely on a high-pass filter to ensure that any subwoofer infrasound is
eliminated.
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2024 IPE Music/Prodipe
Figure 3
Figure 4
Figure 5
Page 17