Prodipe Pro5 v4 Mode D'emploi page 16

2 – Connections
To ensure the proper implementation of your monitor system, please adhere to the following
procedures at all times:
1. Check your audio lead.
2. Switch on the other equipment (audio mixer, computer, audio source, etc.)
3. Check your monitor settings and the settings of your audio sources (lowest volume).
4. Check the voltage (Figure 2), switch on the Prodipe monitors by putting switch (1) in the
ON position and the LED will light up.
Note that: when you want to shut everything down, the Prodipe monitors must be switched off
first, switch (1) in the OFF position and the LED off.
Careful: choosing the "AC Select" (2) voltage depends on your power supply. You should make
any changes when the system has been switched off, switch (1) in the OFF position and the power
supply lead unplugged.
SOURCE
AC SELECT (2)
FUSIBLE (4)
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2024 IPE Music/Prodipe
Pro 7 v4
Pro 5 v4
100V – 220V – 100V –
120V 240V 120V
115V 230V 115V
1A 800mA 2A
1
Pro 8 v4
220V – 100V – 220V –
240V 120V
230V 115V
1A 2A
Figure 2
Pro 10s v4
100V – 220V –
240V 120V 240V
230V 115V 230V
1A 3.15A 1.6A
2
Page 16