Publicité
Les langues disponibles
Les langues disponibles
Follow below advice to enjoy a longer laser lifetime:
Quick on/off switching of this device will reduce durability of the laser diode dramatically.
•
Ensure that device does not get overheated:
•
Switch off device when it is not needed. Diodes are switched on and can wear out even if there is no visible laser output.
o
Switch off device after 1 hour and let the laser cooling down for 15 minutes.
o
Ensure that the fans and heat sinks are free of dust and dirt.
o
ON / OFF
Strobe
Automatic motor rotation
Auto mode 1
Auto mode 2
Auto mode 3
Sound active mode 1
Sound active mode 2
Sound active mode 3
Red laser only
Green laser only
Laser star effect
Red and Green laser
The buildup of dust, dirt and other airborne particles will reduce the unit's light output. It will also prevent the unit from cooling correctly, and this will
reduce the unit's lifetime. The rate of dirt buildup will vary depending on environmental factors such as airborne dust, use of smoke machines, airflow
from ventilation systems, etc. The unit's cooling fans will accelerate buildup, and any smoke particles that are present in the atmosphere will increase the
tendency for dirt to clog.
To get the best performance and lifetime from the unit, inspect it regularly and clean it as soon as you see signs of dirt buildup.
Assess the operating environment each time you begin to use the unit. In dusty or smoky conditions, inspect the unit after a few hours and check it
frequently the unit may attract dirt faster than you expect. Draw up a cleaning schedule that will make sure that dirt is removed before it can build up.
Use the following guidelines:
• Disconnect the unit from power and allow it to cool completely before cleaning.
• Do not use solvents, abrasives or any other aggressive product to clean the unit.
• Vacuum or use low-pressure compressed air to remove dust and loose particles from surfaces and air vents. Prevent the blades of cooling fans
from turning before you aim a vacuum or air jet at the fan, or you may spin the fan too fast and damage it.
• Clean glass components by wiping gently with a soft, clean, lint-free cloth moistened with a weak detergent solution. Put the solution on the cloth
and not on the surface to be cleaned. Avoid rubbing glass surfaces.
• Dry the unit with a soft, clean, lint-free cloth or low-pressure compressed air before reapplying power.
Red LED
Green LED
Blue LED
Automatic LED colour programm
Red and Green LED only
Red and Blue LED only
Green and Blue LED only
Red, Green and Blue colour
Timer function, light will automatically switch off after 1hour.
Timer function, light will automatically switch off after 3hour.
Timer function, light will automatically switch off after 6hour.
Timer function, light will automatically switch off after 9hour.
Publicité
