Publicité
Les langues disponibles
Les langues disponibles
Typical horizontal installation
Mount a mounting bracket (L) or (R) on ei-
E
Select a location where the unit should be
ther side of the main unit with a hex. bolt to-
mounted.
Fix the base brackets with a dou-
gether with double washers (Má x 8).
ble-faced adhesive tape.
©
Mounting
bracket (R)
@ Mounting
bracket (L)
bracket x 2
Hex. bolt with double
washers (M4 x 8)
@ Double-faced adhesive tape x 2
4
Mount the unit on the carpet with four hex.
nuts (M5).
| 3
Use a cutter to cut a small cross in the car-
pet in accordance with the locations of the
M5 bolts of the base brackets.
@ Base bracket x 2
Fix both the base brackets and the double-faced
adhesive tape to a mounting surface below the
carpet.
Relationship between
mounting holes and angles
Mount the unit with the mounting bracket on ei-
ther side with a hex. bolt with double washers (M4
x 8).
Mounting bracket (L)
Mounting bracket (R)
The relationship between mounting holes and an-
@ Hex. bolt with double
Sa
gles of the mounting brackets (L and R) is illustrat-
washers (M4 x 8).
>
5
ed above.
Symbols corresponding to the mount-
ing angles are marked near the respective holes.
Select the correct holes in accordance with the
mounting angles to be used.
neg
17
T CX-DP801EUC
Publicité
