Publicité
Les langues disponibles
Les langues disponibles
16
Installation Guide continued
Q Installation Location
Do not install this unit on the rear tray of a car where the internal temperature can rise to high levels. Failure to
comply with these instructions may cause problems. Also avoid installing the unit in the following locations.
e In areas hit by direct sunlight, hot air from the heater, or any other high-temperature location.
e In an area where you cannot firmly secure the unit, or in high-vibration areas.
© In areas with high humidity or high dirt and dust levels.
How to install this unit
Use a screwdriver to set the angle-adjusting hole to the position "V" or "H," depending on the mounting angle
selected. (When shipped from the factory, the angle-adjusting hole is set to the "H" position as default.)
© When setting vertically: Set to the "V" position.
o When setting horizontally: Set to the "H" position.
Caution
° sa ne
eee
hole to the same angle as | tions: horizontal, vertical, and the posi-
selected.
f
'
tions A (22.57), B (45°), and C (67. 5°).
© Set the holes correctly of the left and right sides | Mount the unit by referring to the fig-
This unit can be set in the five direc-
Angle-adjusting hole
How to install the unit and select the mounting angle
(Norma!)
(Up-side down)
Horizontal:
Set the hole to the same positions for
Limit to less than 10 degrees.
both left and right.
Typical vertical installation
Do not tilt in this
Limit to
(Normal)
(Up-side down) | direction. Limit
tess than
to tess than 10
10 de-
degrees.
Set the hole to the same positions for
both left and right.
_ CX-DP801EUC. :
Publicité
