Publicité
- Any type of watercraft when it is approved and certified by the authorities in the country where it is used.
- Minimal Power requirement: 155 hp when used with the X-Power supply hose / 200 hp when used with the regular hose
- Maximal power requirements: 350 hp
- It is extremely dangerous and not recommended to remove the PWC buoyancy elements.
- Adapters depend on PWC brand and model and are available from our distributors.
- The Hoverboard by ZR® is compatible with the pipe and the rotation system Flyboard® 2013 and 2014.
To connect the Hoverboard by ZR® on the watercraft:
a) Remove the steering and reverse systems.
b) Assemble the pump interface (FB03A08) with the appropriate adapter according to PWC brand and model.
WHERE TO PRACTICE HOVERBOARD BY ZR® ?
The Hoverboard by ZR® can be used in both lakes and open seas when the minimum water depth of 4 meters is respected.
It is strictly forbidden to use the Hoverboard by ZR® in confined spaces such as swimming pools etc.
Do not start the watercraft or use the Hoverboard by ZR® in insufficient water depths (1 meter minimum) with a sandy bottom, it may
damage the Hoverboard by ZR® when used with the electronic kit.
In the event of such use, check the operation of all bearings before further use to avoid breakage of heavy equipment.
Warning! It is the responsibility of the user to make sure there is sufficient depth in the stretch of water used.
To ensure adequate security, we recommend to:
- Check the Hoverboard by ZR® screws HB01062 are tight and secure after 2 hours of use.
- Change the supply hose every 2 years.
- Change the plastic balls of the FB03A03 every year.
- Change the wear ring FB02031 and FB03011 every year.
- The Hoverboard by ZR® should be rinsed with fresh water after each use.
- Do not pull the hose on the floor when full of water.
- The hose should be rinsed, dried and rolled up after each use and stored away from direct sunlight.
The Hoverboard by ZR® should be stored in a dry location and away from direct sunlight.
In order to benefit from the 1 YEAR LIMITED WARRANTY ON THE HOVERBOARD BY ZR®, you must register
on the website www.zapata-racing.com, section "contact" within 15 days after your purchase.
The warranty is limited to the operation and not the visual condition of the parts.
The warranty does not cover parts subject to wear and tear (supply hose, pads, foot straps, bearing plastic balls)
We remind you that warranty is only applicable to parts used as described in the manual.
The Hoverboard by ZR® should be used in its original configuration. It is strictly forbidden and dangerous to modify, remove or add
parts other than those provided by ZAPATA RACING®.
Breakage of equipment caused by extreme violent use will not be covered by warranty.
3. TYPE OF PWC
4. ADAPTATION TO THE VNM
5. MAINTENANCE – AFTER SALES SERVICE
38
UK
Publicité
