Publicité
It is strongly recommended not to use the Hoverboard by ZR® near to any source of risk such as rocks, docks, beaches, boats, banks etc.
Misuse of the Hoverboard by ZR® can result in serious injuries.
- To begin, the Hoverboard by ZR® user should straighten the pipe by taking a direction opposite to PWC, positioning the body flat on the
board (like on a bodyboard).
Then the user must place both feet in the foot straps of the Hoverboard by ZR® while controlling the front of the board:
- If the user prefers to position his left foot forward : he/she will then hold the nose of the board with his left hand
- If the user prefers to position his right foot forward : he/she will then keep the nose of the board with his right hand
- To exit the water, the front leg should be bent and the back leg straight while body weight should be placed on the front. Once the Ho-
verboard by ZR® is on the surface of the water the user must release the hand controlling the nose of the board.
- Once above the surface of the water / flying, the use is very similar to sports such as snowboarding or wakeboarding, the rider controls
the board by shifting weight between the heels or toes.
- To control the height just change the distribution of weight between the front leg and back leg, e.g: by pressing heavily on the Hover-
board by ZR® the rear leg will lift it.
- Pressing again strongly with the front leg will return the Hoverboard by ZR® to the surface of the water.
- Never direct the pressured flow of water in the direction of a person.
- Do not exceed your limits and avoid any aggressive maneuvers to avoid loss of control.
This is a high performance product, not a toy.
- Do not reproduce figures and risk behaviors such as showed on TV or Internet (e.g: back flips). These are performed by professionals.
You risk serious injury, put your life in danger and risk to seriously damage the equipment if the figures are not done perfectly.
- Ensure any trajectory taken opposite the PWC is not too tight, but follow the turn with a radius of curvature of 4 meters minimum. An
aggressive path leads to an over braking of the Hoverboard by ZR® and an abrupt turn of the PWC with the possible following cases:
- Fall of the Hoverboard by ZR® user
- Fall of the PWC driver
- Breakage of the parts FB02020 – FB02021 – FB02022
- Damage the supply hose by causing a separation between the inner and outer wall at the connection with the strap, or may result in an
immediate or delayed tear of the hose.
- Do not turn 360° in front of the watercraft as this may:
a) Damage the supply hose by causing a separation between the inner and outer wall of the hose at the connection with the strap, or re-
sult in an immediate or delayed tear of the hose.
b) Damage the sheath of the cable if the Hoverboard by ZR® is used with the electronic management kit.
36
Publicité
