Abus TVAC25010 Manuel Utilisateur page 17

5. Description of possible connections
5.1 Usage with non PoE compliant feed-in devices
Warning:
Before installation please make sure that the connected device needs a power supply of
12 VDC.
1. Take the injector into operation, the LED will shine red.
2. Now connect the injector with the PoE splitter (TVAC25010), please use therefore a network cable of
the category 5e (e.g. TVAC40800 – TVAC40850).
3. Now connect the splitter with the LAN port and the power plug of the camera, the LED of the splitter
will shine green.
4. As soon as the injector recognizes the splitter, the LED will shine green.
5.2 Usage with PoE compliant feed-in devices
Warning:
Before installation please make sure that the connected device needs a power supply of
12 VDC.
1. If you use a PoE compliant switch, hub or router please connect one of the LAN ports with the LAN
input of the splitter. Please use a network cable of the category 5e (e.g. TVAC40800 – TVAC40850).
2. Now connect the splitter to the LAN port and the power plug of the camera.
3. As soon as a PoE connection is recognized, the LED will shine green.
6. Maintenance and cleaning
6.1 Maintenance
Regularly check the product's physical state, e.g. check for damage of the housing.
If you suspect that safe operation cannot be guaranteed anymore, disconnect the product and ensure
that it cannot be used by mistake.
You can assume that safe operation is not possible anymore when
•
the device shows visible damage,
•
the device does not function anymore
Please note:
The product is maintenance free for you. Inside the product are no parts that can be
checked or repaired, so do not ever open it.
PoE Injector
14
PoE Splitter
English