Publicité
Always Put Safety First!
Read these assembly instructions thoroughly before
beginning. Make sure each step is understood before
attempting it. Be familiar with all safety signs on the
machine and their meaning.
Tighten all fasteners to the torque value specified on
the last page. Recheck before using the machine.
WARNING!
Position the crate in a large open area to allow
access from all sides during assembly.
Stay clear of overhead power lines and obstructions
when lifting the machine during assembly. Contact
with power lines can cause electrocution. Contact
with obstructions can damage components or cause
them to fail.
Keep the assembly area clean to prevent slipping or
tripping.
Use a hoist when lifting components that weigh 50 lb
(23 kg) or more to avoid back injury.
All lifting devices (straps, slings, chains, ratchet
blocks) must comply with applicable local
regulations and certifications. Wallenstein Equipment
Inc. cannot accept responsibility for the use of
sub-standard equipment and work practices.
Use lifting equipment with a capacity greater than the
weight of the component. Place jack stands or wood
blocking under the machine to securely stabilize it
before working on it during assembly.
Use the correct tool for the job. Repair or replace
broken or defective equipment or tools. Makeshift
tools can create safety hazards. A tool that breaks or
slips during use risks personal injury.
WARNING!
Avoid the risk of personal injury or machine damage!
Read the operator's manual before using this
equipment. Carefully read all safety messages in the
manual and follow all safety signs on the machine.
IMPORTANT! Inspect for damage from shipping.
Immediately contact the shipping company if damage
is found.
Note: Some parts are attached to skid with screws.
Shipping brackets are not reused.
Assembly hardware is located inside operator's manual
tube.
Publicité
