Pioneer BDR-S13U-X Manuel De L'utilisateur page 13

Installing the Drive
1 Turn off the power to the computer, and remove the power cable from the AC
socket.
2 Remove the blank panel on the front of the 5-1/4 inch slot.
3 Insert the drive into the slot.
4 If fixing the drive is required, do so in accordance with the computer's user
manual.
5 When installation is complete, remove the protective transparent film on the
front surface of the drive (bezel). If removing the protective transparent film
is not possible after installing in the PC housing, first remove the protective
transparent film before carefully inserting the drive into the computer slot.
• Use screws no more than 6 mm (15/64 in.) in length. Use of long screws may cause
damage to the drive.
• If the screws are not tightened fully, a rattling sound may be caused by vibration
from the rotation of the disc. Therefore, ensure that the drive is installed securely.
• The bottom surface of the product has a black sound dampening and dustproof
sheet attached. Use the drive without removing this sheet.
• Make sure the drive is firmly secured within the PC before use.
• Connect cables to the device only after checking that the cables have not
deteriorated and are not damaged.
13
BDR-S13U-X En