Publicité
Les langues disponibles
Les langues disponibles
SAFETY INSTRUCTIONS
MAINTENANCE / SERVICE
• Never attempt to disassemble, repair or modify the unit yourself. Otherwise, the warranty becomes void. Repairs by
unqualified persons may result in damage or malfunction. Please contact the nearest authorized service center. The light
source contained in this fixture should only be replaced by the manufacturer or its service agent or a person of equivalent
qualification.
• Screens, lenses or UV filters should be replaced if they are visibly damaged to an extent that compromises their
effectiveness, such as by deep cracks or scratches.
• The lamp should be replaced if it has been damaged or deformed by heat.
• Disconnect the unit from the mains before servicing.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer of his
service agent or a smilar qualified person in order to avoid a hazard.
• Never immerse the unit in water or any other liquid. Wipe only with a slightly damp cloth.
• CAUTION : To reduce the risk of fire replace fuse with same type and rating.
PRODUCT INSTALLATION
POWER SUPPLY
Please use the attached power, note that power voltage and frequency are the same as the marked voltage and
frequency of device when connecting power. Every device's power should be connected separately, so that de-
vice can be controlled individually.
DMX CONNECTION
Connection between lights and DMX must use the shied cable of diameter more than 0.5mm. Please use the
attached 3 pin XL plug/socket to connect the DMX output/input interface. The connection between socket and
cable as below (note the plug/socket's 3 pin number and position).
DMX-OUTPUT
XLR mounting-sockets (rear view)
2
When using standard DMX512 control signal, the last device' s output interface must be connected to a DMX plug. This
plug is putting a 120 ohm resistance between "canon" plug' s 2 pin and 3 pin. Showing as below pic. Sticking this plug
into the last device' s signal output interface, it will avoid the interference during the process of signal transmission.
RIGGING
Attention! The installation must be carried out by qualified service personal only. Improper installation can re-
sult in serious injuries and /or damage to property. Overhead rigging required extensive experience! Working
load limits should be respected, Certified installation materials should be used, the installed device should be
inspected regularly for safety.
1 ∙ Shield
2 ∙ Shield (-)
1
3 ∙ Shield (+)
3
DMX-INTPUT
XLR mounting-plugs (rear view)
2
1
3
P.16
PIN3
PIN2
Publicité
