Westfalia 34 06 95 Instructions Originales page 24

Intended Use
 The winch is designed for moving and pulling mobile loads
(rolling/swimming/sliding) within the limits that are specified in
the technical data. It must not be used for moving fixed loads
and for lifting loads.

It is not approved for use in hazardous areas.

The winch must only be operated at 12 V DC current.

The winch may only be operated by using the supplied mounting
plate or in other solid mounting.

Do not use the winch from a motor vehicle with a running engine.
 The winch is not designed for continuous operation.

The intended use also includes an operation following the
operating instructions.
 Any use beyond these parameters (different media, applying
force) or any changes (reconstruction, no original accessory) can
lead to serious risks and is regarded as use that is contrary to
the intended purpose.
Electric Connections
Push the cover (3) in direction of the
1.
arrow to open the compartment for the
electric connections.
Connect the plug of the black cable of
2.
the remote to the corresponding socket
of the winch.
Then connect the plug of the red and
3.
black power cable (7) to the corre-
sponding socket of the winch.
After the steel cable has been attached to the load and all
4.
safeguarding measures have been observed, clamp the clamp of
the black power cable (minus pole) to a suitable part of the vehi-
cle's chassis, e.g. frame or engine.
Operation
20