ledscom LC-SS-9203 Mode D'emploi page 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Loosen the 4 screws (1) on the back of
the wall socket, remove the stainless steel
plate (2) and then the plastic plate (3).
3. Loosen the cable sleeve (4) and guide
the building-side connection cable into the
socket box (5).
4. Connect the building-side connection
cable to the luster terminal inside the
socket box (5) as shown in Figure 2.
5. Fix the connection cable by tightening
the cable sleeve (4) again and close the
socket box (5). Replace the stainless steel
plate (2) and hand-tighten the screws (1).
6. Mount the wall socket on the wall using
the mounting holes (6).
7. Turn the power back on. The installation
is completed.
Subject to technical changes
English
Figure 1
1: Screws
2: Stainless steel plate
3: Plastic plate
Figure 2
Socket (LC-SS-9203) - Assembly instructions
4: Cable sleeve
5: Socket box
6: Mounting holes
07/2024