Miele C2 Titan SDBE0 Instructions D'utilisation page 12

en
Operation
Power cord
,
Unwind the cord completely to
aid the vacuum in dissipating heat.
Do not pull or carry by the cord, use
the cord as a handle, close a door on
the cord, or pull the cord around
sharp edges or corners. Do not run
the appliance over the cord. Keep
the cord away from heated surfaces.
Do not unplug by pulling the cord.
To unplug grasp the plug, not the
cord.
This appliance is equipped with a
power cord reel. Hold the plug when
rewinding onto cord reel. Do not
allow plug to whip when rewinding.
Unwinding (see fig. 19)
^ Hold the plug and pull out the power
cord.
,
To reduce the risk of electric
shock, the vacuum has a polarized
plug (one blade is wider than the
other). This plug will fit in a polarized
outlet only one way. If the plug does
not fit fully in the outlet, contact a
qualified electrician. Do not alter the
plug in any way.
Danger of overheating and damage.
12
Rewinding (see fig. 20)
^ Unplug the vacuum from the outlet.
^ Press the rewind switch - the power
cord will rewind automatically. Hold
the plug so that it does not whip
around when rewinding.
Turning the vacuum on and off
(see fig. 21)
^ Press the On/Off s button.
While vacuuming (see fig. 22 + 23)
^ The vacuum cleaner can also stand
on its end for vacuuming stairs,
drapes etc.
,
To prevent static electricity your
hand must touch the metal inlay on
the underside of the vacuum hand
piece. Be certain to continuously
touch this inlay when vacuuming
fine dust, flour or sawdust as these
materials are more likely to create a
static discharge. To further prevent
static discharge, pull the vacuum
along by the hose with one hand
while continuing to hold the hand
piece in the other hand.
Rotary dial (see fig. 24)
^ Turn the rotary dial to the desired
suction power setting.
Adjusting the suction
You can adjust the suction power to suit
the type of flooring. By reducing the
suction power the floor brush can be
pushed easier.