Husqvarna Flymo ET21 Instructions D'origine page 8

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
WARNING. When using the machine the safety rules must be followed. For your own safety and
that of bystanders please read these instructions before operating the machine. Please keep the
instructions safe for later use.
Explanation of Symbols on your product
Warning
Read the user instructions carefully to
make sure you understand all the controls
and what they do.
Keep bystanders away. Do not operate
10m
whilst people especially children or pets
are in the area.
General
1. This product is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning the use of
the product by a person responsible for their
safety. Children should be supervised to ensure
that they do not play with the product. Local
regulations may restrict the age of the operator.
2. Never allow children or people unfamiliar with the
instructions to use the machine.
3. Stop using the machine while people, especially
children, or pets are nearby.
4. Only use the product in the manner and for the
functions described in these instructions.
5. Never operate the product when you are tired, ill or
under the influence of alcohol, drugs or medicine.
6. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
Electrical
AVOID ACCIDENTAL STARTING, REMOVE PLUG
FROM MAINS AND KEEP FEET AWAY FROM THE
SWITCH LEVER WHEN:- CLEANING AROUND THE
INSIDE OF THE SAFETY GUARD, REMOVING OR
REFITTING SPOOL CAP , MANUALLY FEEDING OR
REPLACING NYLON LINE
1. The use of a Residual Current Device (R.C.D.) with a
tripping current of not more than 30mA is
recommended. Even with a R.C.D. installed 100%
safety cannot be guaranteed and safe working
practice must be followed at all times. Check your
R.C.D. every time you use it.
2. Before use, examine the cable for signs of
damage or ageing. If the cable is found to be
defective, take the product to an Authorised
Service Centre and have the cable replaced.
3. Do not use the product if the electric cables are
damaged or worn.
4. Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is damaged.
Do not touch the electric cable until the electrical
supply has been disconnected. Do not repair a cut
or damaged cable. Replace it with a new one.
5. Your extension cable must be uncoiled or
unwound, coiled or wound cables can overheat
and reduce the efficiency of your mower.
6. Keep the cable clear of the cutting area and
obstacles at all times.
Safety
The use of eye protection is
recommended to protect against objects
thrown by the cutting parts.
Do not operate in the rain or leave the
product outdoors while it is raining.
Switch off! Remove plug from mains before
adjusting, cleaning or if cable is entangled
or damaged.
Warning The cutting line continues to rotate after the
machine has been switched off.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before
disconnecting any plug, cable connector or
extension cable.
9. Switch off, remove plug from mains and examine
electric supply cable for damage or ageing before
winding cable for storage. Do not repair a
damaged cable, replace it with a new one. Use
only Flymo replacement cable.
10. Always wind cable carefully, avoiding kinking.
11. Never carry the product by the cable.
12. Never pull on the cable to disconnect any of the
plugs.
13. Use only on AC mains supply voltage shown on
the product rating label.
14. Our products are double insulated to EN60335.
Under no circumstance should an earth be
connected to any part of the product.
Cables
If you want to use an extension cable when operating
your product, only the following cable dimentions
should be used.
- 1.0 mm
2
: max length 40 m
- 1.5 mm
2
: max length 60 m
- 2.5 mm
2
: max length 100 m
Minimum rating:
1.00mm
2
size cable 10 amps 250 volts AC
1. Mains cables and extensions are available from
your local Husqvarna UK Ltd. Approved Service
Centre.
2. Only use extension cables specifically designed
for outdoor use.
3. If the cable is damaged, it must be replaced by
the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Preparation
1. While using your product always wear substantial
footwear and long trousers.
2. Before using the machine and after any impact, check
for signs of wear or damage and repair as necessary.
3. Inspect the area to be cut before each use. Remove
all objects such as stones, broken glass, nails, wire,
string etc, which can be thrown or become entangled
in the trimmer head.
4. Check that the cutting head, spool and cap are
fitted correctly.
Use
1. Use the trimmer only in daylight or good artificial light.
ENGLISH - 1

Publicité

Table des Matières
loading

Table des Matières