Lindy LH500XW Mode D'emploi page 3

Charging the Battery
1. When the battery is low the LED (7) will flash red and an audio prompt (five beeps) will be heard through the headphones. If you're using
a compatible iOS device you can also see the status of the headphones battery on your device.
2. Plug the supplied USB charging cable in to the charging port on the headphones (1).
3. Plug the other end of the USB charging cable into the corresponding port on either a USB mains power supply or a PC.
4. The LED indicator will light up red.
5. Charging from empty will take approximately 3 hours.
6. When the battery is fully charged, the LED indicator will switch from red to off.
Important! Make sure that the LH500XW are fully charged for at least 4 hours prior to initial use.
Operation
The LH500XW can be used in a number of different configurations to suit your needs; Wired, Wireless, Noise Cancelling and Passive. For
optimum audio performance we recommend using the headphones with Noise Cancelling activated.
Noise Cancelling
1. Adjust the volume of the LH500XW using the Volume Control Dial (8) to ensure the volume is not too high.
2. Switch on the Noise Cancelling feature by sliding the On/Off Switch (9) to On, the Noise Cancelling Indicator (10) will illuminate Blue
3. After you turn the Noise Cancelling feature on you may hear a slight hissing noise, this is normal and will cease after a few seconds.
When using the Noise Cancelling feature, if the battery level becomes low the Noise Cancelling Indicator will become dim. If you
continue to use the Noise Cancelling feature the battery will eventually drain, if you are using a wired connection you may still continue to use
the headphones.
Pairing
1. Switch on the Wireless function by pressing and holding the Multi-Function Button (3). If no previously paired device is found within range,
the LH500XW will automatically go into pairing mode and the LED Indicator will alternately flash Green and Red.
2. Enable the Bluetooth function on your mobile phone or tablet.
3. Navigate to the Bluetooth menu of your device and scan/search for new devices.
4. When LH500XW is found select it and follow the on screen prompts. If you are prompted for a passkey or pin-code, please use 0000.
5. You will see a notification on your portable device confirming that pairing and connection is complete.
Music Playback
Press down the Multi-Function Button
Play/Pause Music
pause your music.
Press the Music/Volume Forward
Play/Pause Music
previous song, Press the Music/Volume Backward
Press and hold the Music/Volume Forward
Adjust Volume
reduce the volume, Press and hold the Music/Volume Backward
In addition the volume can be adjusted using the Volume Control Dial (8).
Call Related Functions
Answer a call
Press the Multi-Function Button once to answer
End a call
Press the Multi-Function Button again to end
Ignore a call
Hold the Multi-Function Button for 3 seconds
Last number redial
Press the Multi-Function Button twice in standby status
Swap calls
Press the Multi-Function Button for 3 seconds
Voice Dialling
The LH500XW can be used for voice dialling if this feature is supported on your mobile phone. Please refer to your mobile phone's manual for
more information. To use the voice dialling feature, press and hold the multifunction button and wait for the voice prompt before saying the
name of the contact you want to call.
once to start playing music and press it again to
Control button to play the next song. To play the
Control button.
Control button to increase the volume. To
Control button.
3