Tornado CV 38/2 Mode D'emploi page 9

Device elements
Illustration on Page 2
1 Indicator lamp on the appliance casing
(red)
2 Cable hook, rotating
3 Handle adjustment
4 Crevice nozzle
5 Upholstery nozzle
6 Nameplate
7 Suction hose on the brush head
8 Locking mechanism of the filter bag
9 Filter bag
10 Unlocking brush head
11 Motor protection filter
12 Filter casing
13 Locking mechanism of the motor pro-
tection filter
14 Locking mechanism of the filter casing
15 Exhaust filter
16 Fastening screw of the side part
17 Side part
18 Turn-lock fastener of the brush cover
19 Brush head
20 Brush roller
21 Brush cover
22 Indicator bundle (red)
23 Indicator lamp - Electronic brush control
(orange)
24 Pile height adjustment knob
25 Filter cover
26 Main switch
27 Suction tube
28 Suction hose
29 Handle
30 Power cord
Electronic brush control
The electronic brush control continuously
monitors the work of the brush roller.
– No light
Brush roller is working properly.
– Orange light is glowing
Set the adjustment knob for pile height
to the lower pile height.
– Orange light also glows at lowest
level
Replace the brush roller.
Note: Visual inspection of the brush: The
degree of wear is shown by a comparison
with the indicator bundle of a different col-
our. When the black bristles are at the
same height as the red ones, replace the
brush roller.
Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the main
switch.
Cleaning operations
Brush roller operation
 Set the pile height via the adjustment
knob of the brush head.
 Perform the cleaning operation.
Suction pipe operation
Illustration
ATTENTION
When you vacuum with the suction hose,
the device must lock into place in home po-
sition in order to allow the brush motor to
switch off.
Turn off the appliance
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
– 2
EN
Operation
9