Tornado CV 38/2 Mode D'emploi page 11

Motor does not run
– No electrical voltage.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
– Thermostat switched off the motor be-
cause of overheating
 Replace blocked filters or remove
blockages from the suction hose.
The unit is operational again after it has
cooled down.
Unsatisfying suction result
 Check the brush roller for obstructing
objects and remove them if necessary.
 Remove obstructions from brush head,
suction pipe and suction hose.
 Replace the filter bag.
 Replace exhaust air filter or motor pro-
tection filter.
 Check the pile height adjustment knob
for correct adjustment.
 Replace the brush roller.
The red indicator lamp on the
appliance casing illuminates
 Remove obstructions from brush head,
suction pipe and suction hose.
 Replace the filter bag.
The orange indicator lamp -
Electronic brush control is ON
 Set the adjustment knob for pile height
to the lower pile height.
The orange indicator lamp -
Electronic brush control is also ON
at lowest level
 Replace the brush roller.
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service center.
Please submit the proof of purchase.
Accessories and Spare Parts
Only use original accessories and spare
parts, they ensure the safe and trouble-free
operation of the device.
For information about accessories and
spare parts, please visit www.kaercher.com.
– 4
EN
Warranty
11