Dogtra ARC HANDSFREE PLUS Manuel Du Propriétaire page 14

3. Once you see the rapidly blinking light, release the
buttons. The transmitter will continue to rapidly blink
until the next step is completed.
4. Hold down the HANDSFREE SQUARE button. Release
the button once the rapidly flashing light on the
transmitter and the HANDSFREE SQUARE both show a
solid light.
5. Release all buttons. The HANDSFREE SQUARE should
now be coded.
6. Up to 14 HANDSFREE SQUARES can be paired with
one transmitter and can have duplicate functions. For
example, 4 can be paired for Pager, 5 can be paired for
Nick, and another 5 can be paired for Constant.
Caution!
Only 14 HANDSFREE SQUARES can be paired. When a
15th HANDSFREE SQUARE is paired, the initial 14 that
were paired will reset and need to be paired again.
24
HANDSFREE SQUARE
Button
5. RECEIVER FITTING
The receiver/collar should be fitted so that the surgical
stainless steel contact points press firmly against the
dog's skin. When properly fitted, you should be able to
fit a finger or two snugly in between the contact points
and your dog's skin. When properly fitted, the receiver/
collar should not move on the dog. The best location
for the receiver/collar box is either side of the dog's
windpipe. A loose fit can allow the receiver/collar to
move around on the dog's neck. When this happens,
the contact points may rub the skin and cause irritation.
If the receiver/collar is too tight, the dogs may have
difficulty breathing.
25