Télécharger Imprimer la page

Dogtra 200C Manuel Du Propriétaire page 15

Publicité

Les langues disponibles

Les langues disponibles

5. My dog has skin irritation.
- This may be due to an improper fit. If your dog exhibits
signs of skin irritation, consult with a veterinarian.
Once the dog's skin returns to a normal condition,
continue to use the collar and check your dog's neck
each time you use the unit.
26
FCC WARNING STATEMENT
FCC Part 15.19
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Part 15.21
Any changes or modifications (including the antennas) to this device
that are not expressly approved by the manufacturer may void the user's
authority to operate the equipment.
FCC and IC RF Radiation Exposure Statement: This equipment complies
with FCC and IC RF Radiation exposure limits set forth for an uncontrolled
environment.
This device and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.
Note : This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications, However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void
your authority to operate the equipment under FCC rules.
27

Publicité

loading