Publicité
Les langues disponibles
Les langues disponibles
KEY-OVERRIDE-SL2
Copyright © 2006
-2009
FORTIN AUTO RADIO INC
1
Connector 1 (Black):
Determine the type of installation:
1.A
INSTALLATION WITH
INSTALLATION WITHOUT DATA-LINK (See p.2)
Connector 2 (White):
1.B
Make the connections associated with the
vehicle in the VEHICLE FITGUIDE (P.1)
PROGRAMMING
Vehicle equipped with SMART KEY
10'
2
3
If the LED is flashing at this point the KEY-OVERRIDE-SL2 module is already
programmed and can't be programmed again. (To prevent malicious use this
module can be programmed in only one vehicle.)
KEY#1
4
KEY#1
5
TECHNICAL SUPPORT / INFORMATION
Neither the manufacturer or distributor of this module is
responsible of damages of any kind indirectly or directly
caused by this module, except for the replacement of this
module in case of manufacturing defects. This module must
be install by qualified technician. This instruction guide may
V
change without notice. isit www.ifar.ca to get latest version.
ALL RIGHTS RESERVED
FORD / JAGUAR / MAZDA / LINCOLN / MERCURY
Make the connections of the KEY-
OVERRIDE-SL2 to the vehicle:
DATA-LINK (See p.2)
Remove all keys from key remote cards
keep the card away from the vehicle (10
feet/3 meters minimum) to proceed with the
programming procedure
Keep programming button pressed while
inserting
connector 1
into the
KEY-OVERRIDE-SL2 module.
Insert the
connector 2
into the
KEY-OVERRIDE-SL2 module.
Release the programming button when the
LED turns ON.
Insert the first functional key into
the ignition barrel and turn the
ignition ON.
When the security light turns OFF,
turn the key to the OFF position and
remove the first key from the
barrel.
SEE VEHICLE FIT GUIDE (P.1) TO IDENTIFY THE SYMBOL.
For the vehicles identif
ro nd
u
symbol
(1 key required)
KEY#1
6
Insert the first functional
key into the ignition barrel
again and turn the ignition
ON.
KEY#1
7
When
the
security light turns OFF,
turn the key to the
position
first key from the barrel.
8.a
For MANUAL
Transmission:
Press and release the
programming button.
The LED will flash 1 time.
8.b
With a jumper wire, apply
power (12v) to the vehicles
ignition wire until the
board security light turns
OFF
. Remove the jumper.
9
Technical support:
TEL: 514-255-HELP (4357)
FAX: 514-255-1367
Web: www.ifar.ca
INSTALLATION GUIDE
Made in Canada - Rev.ZA - 03 / 11 / 2009
W e b
s i t e :
h t t p : / / w w w . i f a r . c a
For the vehicles identified with
ied
with
rectangular symbol
(2 key required)
6
Insert the second functional
key into the ignition barrel and
turn the ignition ON.
7
dash
board
W h e n
OFF
security light turns OFF,
and remove the
the key to the
and remove the second key
from the barrel.
You have 10 seconds to complete one
of the following procedures
Ignition
Activate the remote starter.
12V
dash
If the LED flashes 10 times, the
module is programmed.
If the LED turns ON, repeat from step 1.
You have 5 seconds
to complete the
following procedure
KEY 2
KEY 2
#
#
KEY 2
KEY 2
#
#
t h e
d a s h
b o a r d
turn
OFF position
For
AUTOMATIC
Transmission:
P.4
Publicité
