Powerplus POWXG2007 Traduction Du Mode D'emploi D'origine page 26

8 CLEANING AND MAINTENANCE
Warning! Before performing any work on the equipment, pull the power
plug.
▪
Check your machine regularly before starting the work.
▪
Damaged cutting blades have to be repaired or exchanged by a qualified service man
before working with the machine
▪
After each cutting operation, clean the cutting blade with a soft brush and cloth with
lubricating fluid oil and spray a thin layer of fluid protective oil on the completes blade.
▪
Always keep the ventilation slots in motor housing clean
▪
Never clean or spray a machine with water .clean the motor housing only with a moist
cloth and never apply detergents or solvents! These could ruin the plastic parts of the
machine. Finally, dry the motor housing carefully.
▪
Store the machine with the supplied protection cover.
▪
Only use original accessories and spare parts.
9 TECHNICAL DATA
Type
Voltage ~Frequency
Power input
Blade length
Cutting length
Cutting capacity
No load speed
10 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION!
over 85 dB(A).
aw (Vibration)
Copyright © 2022 VARO
POWXG2007
POWXG2007
230-240V ~50Hz
550 W
525 mm
450 mm
16 mm
1400 /min
89 dB(A)
100 dB(A)
Wear hearing
3,2 m/s²
P a g e
protection when
| 6
sound pressure
K = 1,5 m/s²
www.varo.com
EN
is