Publicité
1 Notes on documentation
1
Notes on documentation
GB
These assembly instructions are aimed at tradesper-
sons who are familiar with assembly and installation
of the cooling unit, and at trained specialists who are
familiar with operation of the cooling unit.
1.1 Associated documents
There are two sets of instructions for the unit types
described here:
– Assembly and installation instructions enclosed
with the unit in the form of a paper document.
– Assembly, installation and operating instructions
enclosed with the unit in the form of a PDF file
(Adobe Acrobat) on CD-ROM.
We cannot accept any liability for damages asso-
ciated with failure to observe these instructions.
Where applicable, the instructions for any acces-
sories used shall also apply.
1.2 CE labelling
The declaration of conformity is supplied with the unit
as a separate document.
1.3 Retention of documents
These instructions and all associated documents
shall constitute an integral part of the product. They
must be supplied to the plant operator. The plant
operator shall be responsible for storage of the
documents, to ensure that they are readily available
when needed.
1.4 Symbols used
Please observe the following safety instructions and
other notes in this guide:
Symbol for an instructed action:
• The bullet point indicates that you should perform
an action.
Safety and other instructions:
Danger!
Immediate danger to life and limb!
Caution!
Potential threat to the product
and its environment.
Note:
Useful information
and special features.
4
2
Safety notes
Please observe the following general safety instruc-
tions when assembling and operating the unit:
– Assembly, installation and servicing must only be
carried out by properly trained specialists.
– Screw the enclosure to the floor to prevent it from
tipping over when the cooling unit is installed.
– Do not obstruct the air inlet and air outlet of the
cooling unit inside and outside the enclosure
(see also section 4.2.2).
– To ensure problem-free opening and closing of the
enclosure door, use a ride-up door roller (refer to
the accessories in the Rittal Catalogue). This raises
the door slightly and balances out the weight of the
cooling unit, to prevent buckling of the door and
associated seal problems.
– The heat loss of the components installed in the
enclosure must not exceed the specific useful
cooling output of the cooling unit.
– When transporting the enclosure with the cooling
unit externally mounted, always use an additional
shipping brace to support the cooling unit.
– The cooling unit must always be transported in an
upright position.
– Only use original spare parts and accessories.
– Do not make any changes to the cooling unit other
than those described in these instructions or asso-
ciated instructions.
– Risk of burn injuries! For cooling units with auto-
matic condensate evaporation, the surface of the
thermal element will get very hot during operation,
and will remain so for some time afterwards.
– The mains connector of the cooling unit must only
be connected and disconnected with the system
de-energised. Connect the pre-fuse specified on
the rating plate.
Rittal cooling unit assembly instructions
Publicité
