Publicité
Les langues disponibles
Les langues disponibles
Changing the lamp
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot be
changed by the consumer. The lifetime of these LEDs is normally sufficient for no change
to be made. If however, and despite all the care taken during the manufacture of your
appliance, the LEDs were defective, please contact your after-sales service for any
intervention.
6. PROBLEMS AND SOLUTIONS
PROBLEM
The appliance is not working
The appliance turns on, but the
temperature is too high or too
low
The appliance is leaking water
The appliance is unusually
loud
POSSIBLE CAUSE
Not plugged in.
Plug and lead are damaged
The circuit breaker tripped or blown fuse.
The temperature control is set at "OFF".
Power supply
Internal wiring fault
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a heat source or air flow to the
condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being stored in the appliance
Appliance is overloaded
The appliance is leaking water
The appliance is not properly levelled
The discharge outlet is blocked
The water container is damaged (call a technician)
The drip tray is overflowing
Loose nut / screw
The appliance has not been installed in a level or stable
position
26
Publicité
