Publicité
Les langues disponibles
Les langues disponibles
To find out more about your product, consult the online EPREL database. As defined in
Commission Delegated Regulation (EU) 2019/2016, all information relating to this
refrigeration appliance is available on the EPREL Base (European Product Database for
energy labeling). This database enables you to consult the information and technical
documentation of your refrigeration appliance. You can access the EPREL Database by
scanning the QR code on the energy label of your appliance or by going directly to:
www.ec.europa.eu and searching the reference of your refrigeration appliance.
3. INSTALLATION INSTRUCTIONS
Before Using Your Unit
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
2 keys
7 shelves
1 Instruction Manual
Before connecting the unit to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Note: if the appliance has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow the appliance to
stand
Recommendation combination :
The following combination of drawers, baskets, and shelves is recommended for energy
or be used as efficiently as possible by the refrigeration unit.
Installation of Your Unit
Place your unit on a floor that is strong enough to support the unit when it is fully
loaded. Set the brakes on the castors to keep the appliance in position. To level
your unit, adjust the legs at the bottom of the unit.
Allow 5 inches of space between the back and sides of the unit, which allows the
proper air circulation to cool the compressor and condenser.
Locate the unit away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly.
Avoid locating the unit in moist areas. Too much moisture in the air will cause frost
to form quickly on the interior surface requiring more frequent defrosting of the unit.
Plug the unit into an exclusive properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a
21
Publicité
