Panasonic CQ-DF802U Manuel D'instructions page 60

Electrical Connections
I
39
Caution:
• This product is designed to operate with a 12 V DC, negative ground battery system.
• To prevent damage to the unit, be sure to follow the connection diagram below.
• Remove approximately
Vf
(5 mm) of protective covering from the ends of the leads before connecting.
• Do not insert the power connector into the unit until the wiring is completed.
• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables
and keep cable terminals free from touching any metal parts.
• Remember, if your car has a drive computer or a navigation computer, the data of its memory may be
erased when the battery terminals are disconnected.
Vi---
)
□ Wiring Diagram
Antenna
External amplifier control lead
<
-i r
(Max.
500
mA)
(Blue/white stripe)
This lead is lor connection to the power amplifier.
Note:
• This lead is used for power control when an external power
amplifier is connected. The power supply of a power amplifier
will be activated when turning on the power of this unit.
Not used.
<
-—
Note: ^
• Insulate this lead with vinyl tape.
V_____/
c
(Brown/white stripe)
Motor antenna relay control lead
◄-
(To motor antenna) (Max. 500 mA)
This lead is not intended for use with switch actuated power antenna.
^Note: ^
• The power antenna extends automatically
when the AM/FM
radio mode is selected.
ACC power lead
<
-
To ACC power, + 12VDC.
Battery lead
+
-
To the battery, continuous +12 V DC.
c
(Dark blue)
Registor (1 kQ)
Fuse (15 A)
—<=l |zz[
ACC
(Red)
BATTERY 15 A
(Yellow)
Ground lead •*- c =
To a clean, bare metallic part of the car chassis.
(Black)
60
CQ-DF802U