Hilti TE 3-ML Mode D'emploi page 12

Total vibration
Chiseling (a )
h, Cheq
Hammer drilling in concrete (a
Drilling in metal (a )
h, D
Uncertainty for the given vibration value (K)
Operation
Fitting the side handle
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶
Remove the depth gauge from the tool.
CAUTION
Risk of injury! Loss of control over the product.
▶
Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is engaged in the groove
in the product.
Fitting/removing the drill bit or other accessory: SDS quick-release chuck
Use of unsuitable grease may cause damage to the product. Use only the recommended grease supplied by Hilti.
TE 3-ML
Fitting/removing the drill bit, chisel or other accessory: Three-jaw chuck
Drilling without hammering
Screwdriving
Drilling with hammering action (hammer drilling)
Setting the chiseling function
Chisel positioning
CAUTION
Risk of injury Loss of control over the chisel direction.
▶
Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function selector switch until it
engages in the "Chiseling"
Forward / reverse
Adjusting the depth gauge
Fitting the dust collection module for overhead work
Pressing/locking the control switch
Replacing the dust shield
Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet can lead to severe injury and burns.
▶
Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries including burns.
▶
Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical specialists.
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
5
TE 3-ML
12.2 m/s²
) 15.6 m/s²
h, HD
5.0 m/s²
1.5 m/s²
position.
TE 3-CL
11.2 m/s²
14.6 m/s²
5.0 m/s²
1.5 m/s²
*2121691*
2121691
3
4
5
6
6
6
6
6
7
8
9
10
11