Power Plus POWEG63703 Mode D'emploi page 43

▪
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
▪
If the external flexible cable or cord is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard
▪
Follow the instructions for safe use, including the recommendation that it must be supplied
with a Residual Current Device (RCD) with a tripping current of not more than 30 mA.
▪
Completely uncoil your extension cable before use to prevent overheating and loss of
mower efficiency. When tidying away the cable, wind it carefully to avoid kinking.
▪
Before use check the supply and extension cord for signs of damage or ageing. If the cord
becomes damaged during use, disconnect the cord from the supply immediately.
▪
Do not cross roads or gravel paths with the machine still running.
7 ASSEMBLY
See Fig.2 a-h
▪
Connect lower handle and the housing with supplied wing nuts, washers & screws.(Fig.2c)
▪
Put the cable strain relief (12) on the upper handle (at side of the switch).(Fig.2a)
▪
Connect upper and lower handle with supplied washer and clamping screws.(Fig.2b)
NOTE : Keep cable on the upper side of upper handle part. Connect the cable to the
handle tube using the 2 supplied cable clamps.
▪
Fit each wheel on the axle, put washer over axel, insert split pen in the hole of the axl and
secure it (bend split pin legs open), then press the wheel covers into place (Fig.2d &2h)
▪
Fix the cable holders.(Fig.2e)
▪
Grass collection box assembly.(Fig.2f): fix lid on lower part of collection box
▪
Lift the flap and place the grass box over the lugs.(Fig.2g)
8 OPERATION
Before connecting to the mains supply, always check the switch is in off
position!
8.1 Adjusting the cutting height (Fig. 3a & 3b)
Make sure your machine is switched off and the knife has come to a complete
standstill before adjusting the cutting height.
ATTENTION: The blades continue to rotate for a few seconds after the
machine is switched off, a rotating blade can cause injury.
For the first cut of the season .a high cutting adjustment should be selected.
The cutting height can be set in 3 heights ; 25, 45 & 65mm.
8.2 To adjust the front wheel cutting height position (Fig. 3a)
▪
Turn the mower upside down.
▪
Pull the wheel axle towards the front of the mower.
▪
Locate the wheel axle into the desired cutting height adjustment position.
Note: Make sure that both front right and left wheels are located in the same
cutting height adjustment position.
Copyright © 2024 VARO
POWEG63703
P a g e | 8
EN
www.varo.com